Develop a Dog Ramp From Plywood

Before you begin, think about the following:
How large and just how heavy is the dog?How frequently will you have to slowly move the ramp?How wide would you like your ramp to become?What is the chance that humans uses the ramp too?The number of ramps will you be needing?

For any dog or humans over 100 pounds, you might need 3/8 or 1/2 inch plywood otherwise you should use 1/4 inch plywood.

When the ramp will be moved frequently, you will likely want as light a ramp as you possibly can. The suggested width is between 16 and 24 inches.

MATERIALS NEEDED
Plywood (for length see Instructions below)Indoor-outside carpeting to pay for one for reds from the plywood4 strips of wooden lathe, each bit as lengthy because the ramp's widthWood or drywall screws
INSTRUCTIONS
Appraise the distance from the top stairs towards the bottomAdd 4 inchesThis can determine the size of the plywood and carpetingCut the plywoodStaple or glue the carpeting to the peak side from the plywoodBeginning in the bottom, screw the lathe crosswise within the carpeting at regular times, for instance every 10 or one footPut the ramp within the steps and allow your dog check it outWhen the ramp is simply too steep, add another two ft of plywood and check out again (screw a bit of board beneath the two sections to become listed on them)When your dog may use the ramp, move it to in which you need it, then anchor the very best finish towards the stairs with screws or nailsMake certain nothing pokes to hurt your canine's feetIn case your steps are constructed with cement, use concrete anchors or concrete nails for fastening

Congratulations, that's all there's to creating a dog ramp from plywood!